Getting Started - MicroNet SP918GL User Manual

Getting Started

A. First, connect the power adapter to the receptor at the back panel of
the 54Mbps Access Point
outlet or power strip. The Power LED will turn ON to indicate
proper operation.
B. Connect your 54Mbps Access Point LAN port with your straight-through Ethernet
cable into a switch/router. Link LED for the LAN Port will illuminate to indicate a proper
connection.
C. Desktop or laptop computers with 802.11b or 802.11.g wireless adapters can connect
to the 54Mbps Access Point.
Right out of the box, with its default settings, the 54Mbps Access Point will
automatically connect with other wireless products
Note: If you are using a DHCP-capable router in your network setup you will
not need to assign a static IP Address.
If you need to assign IP Addresses to the computers on the network, please
remember that the IP Address for each computer must be in the same IP
Address range as all the computers in the network, and the Subnet mask
must be exactly the same for all the computers in the network.
For example: If the first computer is assigned an IP Address of 10.0.0.2 with
a Subnet Mask of 255.0.0.0, then the second computer can be assigned an
IP Address of 10.0.0.3 with a Subnet Mask of 255.0.0.0, etc.
IMPORTANT: If computers or other devices are assigned the same IP
Address, one or more of the devices may not be visible on the network.
and then plug the other end of the power adapter to a wall
IP ADDRESS
10