Data And Fax Calls; Make Calls - Nokia 2125 User Manual

S e t t i n g s
4. Select one of the following
sequence types:
Access no. + phone no. + card
Dial the 1-800 access number,
phone number, then enter the card
number (plus PIN if required).
Access no. + card no. + phone
Dial the 1-800 access number, card
number (plus PIN if required), then
enter the phone number.
Prefix + phone no. + card
the prefix (numbers that must
precede the phone number) and
phone number, then enter the card
number (plus PIN if required).
5. Enter the required information
(access number or prefix and card
number), and select
your entries.
6. Select Card name, enter the card
name, and select OK.

Make calls

After you have saved your calling card
information in your phone, make a call
with your calling card.
1. In the standby mode, select
Menu > Settings
Calling card.
2. Enter your security code, and
select OK. See "Lock
3. Scroll to the calling card of your
choice, select Options
OK.
32 Copyright © 2005 Nokia. All rights reserved.
no.—
no.—
no.—Dial
OK to confirm
> Call settings >
code", p. 39.
> Select >
4. Press the end key to return to
standby mode, and enter the phone
number, including any prefix
(such as 0 or 1) that your calling
card may require when you make a
calling card call. See your calling
card for instructions.
5. Press and hold the call key for a few
seconds until Card call
6. When you hear the tone or system
message, select OK.

Data and fax calls

Data or fax calls is a network service.
See "Network services", p. viii.
If your wireless network operator
supports this feature, you can set up
the device to send or receive data or
fax calls when a terminal, such as a
PDA or PC, is connected.
For better performance during data
calls, place the device on a stationary
surface. Do not move the device by
holding it in your hand during a data
call.
For more information on connectivity,
see the PC/PDA Connectivity Guide.
The PC/PDA Connectivity Guide can be
downloaded from the Nokia web site
at http://www.nokia-asia.com.
1. In the standby mode, select
> Settings > Call settings
fax calls > Incoming data/fax call
and one of the following options:
is displayed.
Menu
> Data/