Hitachi CP-X9110 User Manual page 2

Example of computer signal
Resolution (H x V) H. frequency (kHz)
*1 1280 x 1024
*2 1400 x 1050
*3 1680 x 1050
*1 1600 x 1200
*4 1920 x 1200
*1) Supported except for HDMI
*2) Only for CP-X9110.
*3) Only for CP-WX9210 and CP-WU9410.
*4) Only for CP-WU9410, but except for HDMI
NOTE • Be sure to check jack type, signal level, timing and resolution before
connecting this projector to a computer.
• Some computers may have multiple display screen modes. Use of some of
these modes will not be possible with this projector.
• Depending on the input signal, full-size display may not be possible in some
cases. Refer to the number of display pixels above.
• Although the projector can display signals with a resolution up to UXGA
(1600x1200) or up to W-UXGA (1920x1200) for CP-WU9410, the signal will be
converted to the projector's panel resolution before being displayed. The best
display performance will be achieved if the resolutions of the input signal and
projector panel are identical.
• Automatic adjustment may not function correctly with some input signals.
• The image may not be displayed correctly when the input sync signal is a
composite sync or a sync on G.
• The illustrations in this manual are for illustrative purposes. They may differ
slightly from your projector.
2
V. frequency (Hz)
91.1
65.2
65.3
75.0
74.0
input.
TM
TM
Rating
85.0 VESA
60.0 VESA
60.0 VESA
60.0 VESA
60.0 VESA
input.
Signal mode
SXGA (85Hz)
SXGA+ (60Hz)
WSXGA+ (60Hz)
UXGA (60Hz)
W-UXGA (60Hz)
Reduced Blanking