Safety Warnings - Advanced Digital SimpleServo SS504 User Manual

Safety Warnings

m
• The warning symbol shown at left denotes an important safety consideration. Please read this manual
carefully before performing any of the procedures contained herein. Failure to follow these instructions
may result in fire, severe injury, or fatality.
• Have a qualified electrical maintenance technician install, adjust and service this equipment. Follow the
National Electrical Code and all other applicable electrical and safety codes, including the provisions of
the Occupational Safety and Health Act (OSHA), when installing equipment.
• The question mark symbol shown at left denotes shortcuts, reminders, or additional information which
does not affect the safe operation of the drive.
• Reduce the chance of an electrical fire, shock, or explosion by proper grounding, over-current
protection, thermal protection, and enclosure. Follow sound maintenance procedures.
m
• It is possible for a drive to run at full speed as a result of a component failure. Please ensure that a
master switch has been placed in the AC line to stop the drive in an emergency.
• Circuit potentials are at 115 VAC or 230 VAC above earth ground. Avoid direct contact with the
printed circuit board or with circuit elements to prevent the risk of serious injury or fatality. Use a non-metallic
screwdriver for adjusting the calibration trimpots.
3