Infinity Entra Center Owner's Manual page 3

I S
NSTALLING PIKED
Entra Two and Entra Three
Refer to Figure 4 as you perform the following steps:
1. The Entra Two and Entra Three come with the round end of
their feet exposed for use on hard-surface floors.To expose
the spiked end of the feet, lay each speaker on its side and
use the enclosed wrench to unscrew and remove the four
feet. Screw the round end of each foot into its hole and
hand-tighten a nut onto each foot. Leave a minimum of 5/8"
of exposed spike. (On thicker carpets, you can increase the
length of exposed spike up to 1-1/8. " )
2. Carefully stand each speaker upright to sit on its feet.
3. If needed, adjust the feet so each speaker is level and then
tighten each nut with the enclosed wrench.
of Speaker
Locking Nut
⁄ "
5
min.
8
⁄ "
1 1
max.
8
spike end
CARPETED
FLOORS
F 4
– This cross section shows how to install a foot
IGURE
onto the bottom of an Entra floorstanding speaker.
F
EET
Bottom
5 ⁄
8
Foot
round end
Nylon Dome
(optional for
wood floors)
HARD-SURFACE
FLOORS
"
ENTRA
3