Download Print this page

PC Electronics TX33-.1s User Manual

70 cm atv transmitter

Advertisement

Quick Links

TX33-.1s 70 CM ATV TRANSMITTER
The TX33-.1s transmitter is designed to provide 50-100 milliwatts peak envelope power (sync tip)
of video modulated RF in the 33 CM (902-928 MHz) amateur band on any of 5 switch selected frequencies
- 910.25, 911.25, 913.25, 919.25 and 923.25 MHz. For higher power, a Downeast Miicrowave 3340PA
linear amplifier can be added.
Any licensed Technician class or higher Radio Amateur may operate this transmitter in accordance
with 47 CFR part 97 of the FCC Rules and Regulations.
The TX33-.1s accepts U.S.A. standard composite video (1 volt pk-pk) from any source such as
color or black and white cameras with video output or camcorders, VCR's, or DVR's for transmission.
Audio from these sources or a low impedance dynamic mic is also transmitted on the 4.5 MHz sound
subcarrier. Transmit / receive power and antenna switching is provided for a companion high sensitivitty
TVC-9s downconverter connected to a TV on channel 3 may be used to receive:
PLEASE read through this manual before plugging in an cables and attempting operation. Each
connector and control is described here to enable your proper hookup and operation. Also the unique
video practices associated with ATV and the 33 CM band are described. More information on ATV can
be found on our Application Notes web page at www.hamtv.com.
P. C. Electronics 2522 Paxson Lane Arcadia CA 91007-8537 USA
1-626-447-4565
Tel:
Web site: http://www.hamtv.com
USERS MANUAL
m-th 8am-5:30pm pst
(UTC - 8)
Email: ATVinfo @ hamtv.com
1
Tom
& Mary Ann
(W6ORG)
©2011
(WB6YSS)

Advertisement

loading

Summary of Contents for PC Electronics TX33-.1s

  • Page 1 47 CFR part 97 of the FCC Rules and Regulations. The TX33-.1s accepts U.S.A. standard composite video (1 volt pk-pk) from any source such as color or black and white cameras with video output or camcorders, VCR’s, or DVR’s for transmission.
  • Page 2: Rear Panel

    XMIT / REC switch is in REC and open when in XMIT. 2 AMP FUSE INSIDE. The TX33-.1s itself draws less than.5 amp in transmit, and .1 amp plus external downconverter in POWER INPUT JACK. A 4 pin plug 2 ft cable is provided for receive - A 1.0 amp 3AG fuse should handle both.
  • Page 3: Front Panel

    928 MHz ATV downconverter. Downconverters for other It is independent of the line audio level. Speak directly into bands are not connected to the TX33-.1s, but rather to their the microphone at the normal operating distance. Increase own antenna and left on when transmitting on 33cm for full the level to the point where the red XMIT light winks off, and duplex or crossband repeat.
  • Page 4 ARRL SCM, connected to a good 50 Ohm dummy load or low vswr or pick a night and time to start an ATV net. The TX33-.1s is antenna (less than 10% reflected).