Time Function; Delay Start; Child Lock; Starting The Programme - AEG LAVATHERM 56740 User Manual

12 Daily use
To deselect function press again BUZZER button (3). The LED above is off.

TIME function

To select the programme duration after setting the TIME PROGRAMME . You can select a
programme duration from 10 mins to 3 hrs in 10-minute steps.
1. Turn the programme knob to the TIME PROGRAMME. The blinking 10' appears in the
display. (corresponding to the cooling phase).
2. Press the TIME button (4) repeatedly until the desired programme duration is shown in
the display, e.g.
If the programme duration is not selected, the duration is automatically set to 10 mins.

DELAY START

With the DELAY START button (6), you can delay the start of a programme by be-
tween 30 minutes (30') and a maximum of 20 hours (20h).
1. Select the programme and additional functions if necessary.
2. Press the DELAY START button (6) as many times as necessary until the required start
delay appears on the display, e.g.
If the display is showing 20h and you press the button again, the time delay will
be cancelled. The display will show 0' and then the duration of the selected pro-
gramme.
3. To activate the delay timer, press the START PAUSE button (5). The amount of time
remaining until the programme is set to start is continuously displayed (e.g. 15h, 14h,
13h, ... 30' etc).
The delay time icon

Child lock

The child lock can be set to prevent a programme being accidentally started or a programme
in operation being accidentally changed. The child lock function locks all buttons and the
programme knob. The child lock can be activated or deactivated by holding down the
BUZZER (3) and TIME (4) buttons simultaneously for 5 seconds.
– Before programme is started: Appliance cannot be used
– After programme is started: Programme in operation cannot be changed
The icon appears in the display to indicate that the child safety device is activated.
The child safety device is not deactivated once the programme comes to an end.
If you want to set a new programme, you must first deactivate the child safety device.

Starting the programme

Press the START PAUSE button (5). The LED above stops flashing, becomes steady. The
programme is started. Display shows elapsing cycle time or delay time if activated.

Changing programme

To change a programme which has been selected by mistake once the programme has
started, first turn the programme selector to OFF and then reset the programme.
for a programme of 20 minutes.
if the programme is to be started in 12 hours.
is on.