Setup; Show Drives - Talon Pro User Manual

Setup

To view the setup option, turn on the system. The system always displays an operation Status
(e.g., copy or emulate, etc.) at system startup. Press the Status button until it chirps. Then
release it. You should see the word setup in the display window, as shown below:
setup
<Statu
s
The setup option functions as a source for two menu lists:
§
Sub-Functions, and
§
Other System Capabilities.
Pressing the Start button when setup is displayed leads the user into the list of sub-function
options.
Pressing the Status button when setup is displayed leads the user into the list of "Other System
Capabilities," (These are described starting on page 31.)
Press the Start button to proceed through the list of sub-functions.
With setup displayed in the LCD display panel, press and hold the Status button to return to
viewing an operation Status.

Show Drives

This is not a setting as much as it is an information list, showing the types of drives in the system.
The CD drives are TEAC or Lite-On drives. Pressing the STATUS button shows each name of
the drive as identified in the options list below.
Drives in the Talon CD Duplicator System:
TEAC
Lite-On
If you were to press the Status button, you could change the CD to CD sub-function from No to Yes.
When its setting is No, then the system will assume you are copying from the selected partition on the
hard disk. If you change this sub-function item to Yes, then the system will assume you are using the first
CD drive as the CD Reader, and that you are copying from the original CD.
Options:
No (default)
Yes
24
Start>
CD-W540E ATA2.0
LTR2015
1.0B
Talon CD Duplicator