Table of Contents
Advertisement
1
2
3
ATTENTION!
1 AC MAINS INPUT: The T 587 comes supplied with a separate AC Mains
cable. Before connecting the cable to a live wall socket, ensure first
that it is firmly connected to the T 587's AC Mains input socket. Always
disconnect the AC Mains cable plug from the live wall socket first,
before disconnecting the cable from the T 587's Mains input socket.
2 COMPONENT VIDEO OUT: Connect to the corresponding component
video input of a compatible equipment like a monitor/television,
projector, A/V receiver or processor. Be sure to observe consistency
in connecting the appropriate Y/ Pb/Pr jacks to the corresponding
sources/inputs. Do not rely purely on the color coding of the jacks,
which may not always be consistent among brands.
3 VIDEO OUT: Connect to the corresponding composite video input of
a compatible monitor/television, projector, A/V receiver or processor
using quality dual-RCA cable designed for video signals.
4 AUDIO OUT: This analog audio output can be connected to the
corresponding analog audio input of a compatible equipment like an
amplifier, receiver, TV or stereo system.
5 DIGITAL OUT (COAXIAL, OPTICAL): The digital playback audio output
signal is available at these ports. Connect the optical or coaxial digital
OUT ports to the corresponding S/PDIF digital input of an amplifier,
receiver, computer soundcard or other digital processors.
6 HDMI OUT: Using a HDMI cable (supplied only for European version
model), connect the HDMI OUT jack to the corresponding HDMI input
jack of a compatible equipment like a HDTV, a projector or an A/V
Receiver.
Dolby TrueHD, Dolby Digital Plus and DTS-HD Master Audio are
supported with maximum 7.1 channels when HDMI OUT is the selected
audio output port. Make sure to connect to an amplifier or receiver with
a built-in (Dolby Digital, Dolby Digital Plus, Dolby TrueHD, Dolby Digital
Plus, DTS-HD Master Audio and other applicable formats) decoder to
playback applicable multichannel audio formats.
WARNING
4
5
6
7
IMPORTANT NOTICE
7 LOCAL AREA NETWORK (LAN) PORT: Using a commercially available
NOTES
8 IR IN: This input is connected to the output of an IR (infrared) repeater
IDENTIFICATION OF CONTROLS
8
straight LAN cable (Category 5/CAT5 or better with RJ45 connector),
connect this LAN port to the corresponding port of your modem
or router. By connecting the T 587 to broadband internet, you can
playback a disc that offers BD-Live function. Refer also to the "NETWORK
SETUP MENU" section of "USING THE T 587" under the "OPERATION" main
heading.
internet connectivity.
about such content availability or compatibility.
(Xantech or similar) or the IR output of another component to allow
control of the T 587 from a remote location. Most NAD products with IR
OUT are fully compatible with the T 587.
REAR PANEL
9
Advertisement
Table of Contents
