Grizzly Model G8592 Instruction Manual page 8

OPERATION
Handle Position and Switch
The driver and flashlight are both jointed in
the center to adjust to different types of
use. Adjust the angle to whatever is com-
fortable for the job to be done (See Figure
4.)
Lock Switch
Fwd/Rev Switch
Fig 4. Positioning the handle and switch
location.
The driver has a two position rocker switch
with forward and reverse. If you want to
tighten a screw, push on the top of the
switch to drive clockwise. To operate
counterclockwise, push the bottom portion
of the switch.
There is also a locking switch just above
the forward/reverse switch. This allows
you to lock the tool to prevent accidental
use of the tool. You should always use the
LOCK position when placing, removing or
adjusting bits or when removing the bat-
tery.
The flashlight has only a slider ON/Off
switch on the top of the case.
-8
-
Removing Battery From Tool
The battery can be removed by pressing
on the two circular depressions at the end
of the handle and pulling away from the
tool. When reinstalling the battery, be sure
the elongated end of the battery is aligned
with the slots on the inside of the compart-
ment. The battery will lock into position
when fully inserted.
Operating this equipment has the
potential to propel debris into the air
which can cause eye injury. Always
wear safety glasses or goggles when
operating equipment. Be certain the
safety glasses you wear meet the
appropriate standards of the
American National Standards
Institute (ANSI).
G8592 3.6V Cordless Screwdriver/Flashlight