Summary of Contents for DrRobot MAC5310
- Page 1 MAC5310 Audio Codec and Audio Power Amplifier Module User Manual Version: 1.0.1 Nov. 2003...
- Page 2 Table of Contents Introduction Operations II.1. Theory of Operation III. Connections III.1. Board Structure III.2. Connector Description Specifications Copyright © Dr Robot Inc. 2003.
- Page 3 II.1. Theory of Operation The MAC5310 Module is designed to run as part of WiRobot system. It can be directly plugged on to the PMB5010 Robot Multimedia Controller board. No configuration procedure is needed. Once connected, the PMB5010 on-board firmware and the audio input/output device driver will take care of the low level operations of the voice/speech capturing and audio output.
- Page 4 Figure III.1 MAC5310 Connector Locations III.2. Connector Description The definitions of the MAC5310 connector signals are listed in the following tables. Table III.1 Speaker Connector SPEAKER Name Function Speaker output 1 Speaker output 2 Table III.2 Microphone Connector MICROPHONE Name...
- Page 5 Specifications Table IV.1 MAC5310 Specification Parameter Conditions Unit Power Supply Voltage Power Supply Voltage Output Power THD = 0.5%(max), f = 1 kHz, = 8 Ohm THD + N = 0.5%, f = 1 kHz, = 8 Ohm Analog input voltage, peak- = 3.3 V...
Need help?
Do you have a question about the MAC5310 and is the answer not in the manual?
Questions and answers