Table of Contents
Advertisement
6. Troubleshooting
Problem
The circuit breaker is activated
(tripped).
The switching command is not
carried out, the rocker switch
and indicators are not lit.
Software reports "Device I/O
request error" after switching
Timer schedule is delayed
GEMBIRD EUROPE B.V.
PROGRAMMABLE SURGE PROTECTOR
The load connected to the device is too
high, some of the devices connected to
the SIS-PMS should be disconnected and
the circuit breaker should be reset.
There is no power supply to the SIS-PMS.
Please, make sure the SIS-PMS is
connected to the power supply and the
rocker switch is switched on.
Check the grounding of SIS-PMS. If
inductive load, like florescent lamps or
motors are connected to SIS-PMS, it is
recommended to use an extra USB hub to
connect
SIS-PMS
computer.
Do not power SIS-PMS off when the
hardware timer schedule is active. Press
the "Silence" button, every push will
reduce the delay with one minute.
http://www.gembird.eu
SIS-PMS
Solution
to
the
managing
39
Advertisement
Table of Contents
Need help?
Do you have a question about the USER MANUAL and is the answer not in the manual?
Questions and answers