Luxor LUX-TUTV-500GB User Manual page 9

Power On-Off
Connect all cables before plugging into the mains. After plugging in the mains cord of the set-top-box to the mains
supply, a light will be seen on the front panel (Standby mode). When the set-top-box is  rst powered up please
wait until the box is initialized before activating the receiver since booting of software will take some time. Make
sure that all cable connections are in place. Plug the mains. Please wait until unit is initialized. This may take
almost a minute.
This product conforms the latest European Union Power Consumption Regulations and features low power standby
mode. Product enters into the low power standby mode approximately 2-3 minutes later after you press standby
button to turn off the unit. Until low power mode is activated, clock will be displayed at the display. When the low
power mode is activated, display will be shut down. When you press standby button during low power mode, it may
take a minute until product is initialised. However if you press standby button before low power mode is activated
unit will be initialized in a couple of seconds (Active standby mode). Although it is not recommended for enviromental
reasons, you may disable low power mode in your product at setup –con guration menu.
Auto Power Down:
This box will automatically switched from active mode into standby mode, after less than three hours in active mode,
following the last user interaction and/or a channel change with an alert message two minutes before going in to
standby mode. The Automatic power-down will be set as default and the user will be able to change Automatic
power down to on or off in the menu.
Important Note : If there is any ongoing programme recording or if any EPG programme recordings and/or manual
recordings is set to a nearby time, the unit does not switch to low power mode and remains in active standby mode
until recording tasks have been  nished. At low power mode, the unit initializes a couple of minutes before the
actual time of the incoming recording task.
Important Note : The unit initializes time to time to receive updates from EPG broadcast in order to sycnronize
EPG recording tasks properly. After getting updates, the unit switches to low power mode automatically. This takes
a short while and it is not a malfunction.
English - 8 -