Charging Your Unit - Humless Sentinel User Manual

Charging
Your Unit
User Instructions
• Insert red key into keyhole. Turn right for "ON;" turn left for
"OFF." Do not turn on unit first when charging with
instructions under
• Push and hold green button for three seconds to check battery status.
• When not in use, turn off all power, including switches, and remove key.
To Charge
• Provide a minimum of 6 inches of clearance on all sides of the unit. DO
NOT cover or obstruct cooling fan vents; otherwise, overheating
could occur.
• Insert red key into ON/OFF keyhole. Turn right for "ON;" turn left for "OFF."
• MAKE SURE VOLTAGE AND AMPERAGE OF BOTH CHARGING
SOURCE AND UNIT ARE COMPATIBLE.
• Instructions are the same for charging AC and DC options:
• AC
• DC
Input C
m
m
m
AC
•
charged, the charger light will turn green.
• DC
or fully charged.
• Store unit fully charged.
Consult with your power source manufacturer to verify proper voltage
and amperage compatibility.
12
"To Charge."
Input: Connect AC plug into
Input: Connect DC plug into
(12V 10 A) and also into the charging source.
When using Input
correct positive and negative terminals.
On unit, red is the positive-side terminal; black is the
negative-side terminal.
WAIT TO TURN ON POWER WITH RED KEY UNTIL LEADS
ARE CONNECTED.
Input: When charging, the charger light will be red. Once fully
Inputs: When charging, the charger light is red when charging
Input A
Input B
C, make sure that you connect leads to the
Input C. Read
(120-240 V) and wall/generator.
(12V 16 A) or