Subscribe to Our Youtube Channel
Summary of Contents for Peecker Sound UPTURNED T Series
- Page 1 User’s Manual UPTURNED T series Upturned T USER’S MANUAL SOUND REINFORCEMENT SOUND REINFORCEMENT CONTROLLED RADIATION CONTROLLED RADIATION ACOUSTIC RESEARCH ACOUSTIC RESEARCH...
-
Page 2: Table Of Contents
User’s Manual UPTURNED T UPTURNED T series series TABLE OF CONTENTS pag. 3 1. SAFETY 2. GENERAL INFORMATION pag. 3 pag. 3 3. CLOSE-UP VIEW OF THE MODELS 3.1 PSUT8TE and PSTU8AE 3.2 Loudspeaker mixed orientation: a careful study 3.3 PSUTBASE/A 3.4 PSUT1 3.5 PSUTS 4. - Page 3 “base” of the column that looks as an upturned T. The Upturned T series has a wide range of applications based on the particular type of audio system under consideration.
-
Page 4: Loudspeaker Mixed Orientation: A Careful Study
Figure 4. Horizontal (red line) and vertical (blue line) polar pattern of a PSUT8AE model with the real arrangement of the loudspeakers’ angles as designed and set up by Peecker Sound engineers Figure 2. The loudspeakers at the bottom have a wider horizontal sound beam (blue in the figure) and thus ensure adequate coverage for both musicians and the first rows of the audience. - Page 5 User’s Manual UPTURNED T series 3.3 PSUTBASE/A 3.4 PSUT1 The active subwoofer PSUTBASE/A with 12” reflex loudspeaker with The PSUT1 is a small loudspeaker system fitted with one single 4” full-range Neodymium magnet was purposely designed for the formation of active transducer with Neodymium magnet and 16 Ohm impedance.
-
Page 6: Psuts
User’s Manual UPTURNED T UPTURNED T series series 3.5 PSUTS 4. OPERATING INSTRUCTIONS FOR UT ACTIVE STACK SYSTEMS This subwoofer has two 6” reflex coupling loudspeakers and 8 Ohm overall 4.1 Description of the elements in an active stack impedance. PSUTS subs are used together with a variable number of PSUT1 modules and can be installed both on the floor or on the wall (better if close We have already covered the application of the PSUTBASE/A subwoofer to the ceiling) by means of dedicated accessories. - Page 7 User’s Manual UPTURNED T series Note: the resulting strong directivity requires a very accurate use of the active 4.3 Array effect stack systems that are highly suitable for any location with a limited vertical beam (for example, flat-floor or slightly lowered audience stalls), but not for UT Active Stack systems fall under the loudspeakers array category.
-
Page 8: Presetting
User’s Manual UPTURNED T UPTURNED T series series 4.5 Presetting 4.6 Concurrent use as stage fill and main P.A. There are two buttons on the back panel of the PSUTBASE/A to select any of UT Active Stack systems are perfect for simultaneous use as a main P.A. and the 4 default presets for different systems or situations. -
Page 9: Live Applications: Considerations
User’s Manual UPTURNED T series The 1_1 system, on the other hand, is best for an audience that is not sitting 4.7 Live applications: considerations very close to the systems, for standing audiences that are not crowded over very large areas or do not need high peaks of the medium-low frequencies. Upturned T active stack systems are perfect for acoustic live performances where they provide an excellent performance/dimensions ratio. -
Page 10: Summary Table
User’s Manual UPTURNED T UPTURNED T series series 4.9 Summary table The following table refers to the use of active stacks. COVERAGE SYSTEM APPLICATION AND USE REMARKS AND DISTANCE A) Placed at the back of the stage Stage width: 4-5 m (works as both a monitor and a P.A.) A slightly angled and off-centred position can optimize the stage coverage. -
Page 11: Amplification And Limitation
On the other hand, it is impossible to protect the speakers from harmful (see System configuration section of the Upturned T series). For configurations phenomena originating from within the amplifier by acting on the with the PS1000 amplifier, the anti-clip limiter onboard the amplifier must be incoming audio signal to the amplifier. -
Page 12: Connections
For stereo configurations, Peecker Sound PS650-F 4-channel amplifier of another sub and/or a system made up of several PSUT1 micro-speakers. with PS266 processor or a set of two Peecker Sound PSDSP series The PSUT1 satellite has only one set of spring connectors to be also used for amplifiers can be used (see paragraph 6: “System configurations”). -
Page 13: Installation Of Passive Systems From A Functional And Acoustic Point Of View
User’s Manual UPTURNED T series 5.6 Installation of passive systems from a functional and acoustic point of view • PSUT8TE e PSUT8AE Besides forming active stack configurations together with the active PSUTBASE/A subwoofer, the PSUT8TE and PSUT8AE column speakers can be installed, single or in a stack, without any subwoofer and powered by external amplifiers. - Page 14 User’s Manual UPTURNED T UPTURNED T series series NUMBER OF PSUTS NUMBER OF PSUT1 INSTALLATION REMARKS Speech or background music. Various elements in a UP TO 4 IN PARALLEL Single, in sets of 2 or clusters of 4 PSUT1 cluster produce bass reinforcement and hence deeper sound and better clarity at distance Sub and satellite combined (sub on the Basic sound reinforcement system...
- Page 15 User’s Manual UPTURNED T series 5.7 Rigging Instructions Listed below are the dedicated UT series accessories for the fastening of passive systems. PHOTO CODE DESCRIPTION STD-WUT8 Wall brackets for vertical hanging of PSUT8TE or PSUT8AE loudspeakers Wall bracket for vertical hanging of 1 or 2 PSUT1 loudspeaker systems STD-WUT1 (H and V rotation of 180°) Wooden base for PSUT8xx with butterfly hooks.
-
Page 16: Power Cables - Section/Length Table
User’s Manual UPTURNED T UPTURNED T series series 5.8 Power cables - section/length table 6. SYSTEM CONFIGURATIONS It is very important to use power cables of appropriate section. The length of 6.1 UT Active Stack configurations the cable causes a significant impedance that can deplete the audio signal and change the dumping factor of the amplifier-speaker couple. -
Page 17: Psut1+Psuts Configurations
User’s Manual UPTURNED T series 6.3 PSUT1 + PSUTS configurations 6.4 Surround configurations The configuration Surround 1 is designed for sound reinforcing outdoor cinemas with a portable system, without the need of hanging speakers and with the ability to enjoy the surround sound effect and the L.F.E. (Low Frequency Effect) channel present on video supports. -
Page 18: Psutbase/A
User’s Manual UPTURNED T UPTURNED T series series Figure 26. Surround 1 configuration with PSUT8TE, PSUT8AE and PSUTBASE/A Figure 27. Surround 2 configuration with PSUT8TE, PSUTBASE/A and PSUT1 SOUND REINFORCEMENT SOUND REINFORCEMENT CONTROLLED RADIATION CONTROLLED RADIATION ACOUSTIC RESEARCH ACOUSTIC RESEARCH...
Need help?
Do you have a question about the UPTURNED T Series and is the answer not in the manual?
Questions and answers