Replacement Parts List; Troubleshooting Guide - Pinnacle Aero Bella AB-716C-QH User's Manual And Operating Instructions

NEVER LEAVE HEATER
UNATTENDED WHILE
OPERATING
Maintenance / Storage
NOTE: Before care or maintenance is applied, be sure
heater is not plugged in.
The cabinet housing can be wiped down with a damp cloth
or with furniture polish. Your heater comes with a
washable filter. The filter should be cleaned regularly for
maximum performance. Remove the filter from the heater,
and run warm water over and through filter to remove dirt
and dust. If desired you can use a mild soap to help
remove dirt and dust. Shake water from filter and replace
in heater (a damp filter can be replaced into the heater).
NOTE: Repair of this heater should be done by a quali-
fied service person.
It is recommended that you save all of the packaging
materials that came with your heater, and re-package the
heater using these materials for safe storage.
Debris, dust and dirt inside of the heater body can affect
the performance of your heater. This debris can impair the
heaters ability to draw air for ventilation.
The Manufacturer reserves the right to make any changes in materials, specifications, prices or design without notice.
The Manufacturer may also discontinue items at any time.

Troubleshooting Guide

Problem
Heater does not turn on
Heater continues to operate
after power switch is turned
off.
The amount of heated air
leaving the front of the
heater is reduced.
Page 4
Possible Cause
1. No power from outlet
2. Not pluged in
3. MASTER POWER switch is off.
4. TIME is flashing on LED
1. Heater is in cool down mode
1. Filter is dirty
2. Vents are blocked
Aero Bella
TM

Replacement Parts List

Item Part Description
Number
1 Remote Control
2 Filter
3 Castor
4 Quartz Bulb
1. Be sure outlet is in working order.
2. Be sure heater is plugged in.
3. Press MASTER POWER switch.
4. Press POWER button to turn off TIME and
resume normal operation of the heater.
1. Do not unplug the heater. The fan will continue to
operate even after the power switch is turned off.
The heater is in cool down mode. Once the fan
has stopped, it is safe to disconnect the power
cord.
1. Check your electrostatic filter to make sure it is
free from dust and dirt, and clean if necessary.
2. Be sure the front grille and rear vent intake are
not being blocked.
Infrared Quartz Room Furnace
Infrared Quartz
Room Furnace
Part Number
84-001-0100
84-002-0100
84-003-0100
84-005-0100
Solution