Advertisement
Replacement Parts
Contact your local Everpure dealer for filter cartridges or system
replacement parts.
Description
Outlet pressure gauge
Inlet pressure gauge (quad system only)
Inlet valve (twin, triple, & quad)
Flushing valve
Pressure Gauges
LOW
INLET PRESSURE
Cartridge Change Procedure
Everpure Carbon Filter
Cartridge Change
1. Shut off power to equipment.
Shut off inlet water ahead of
system.
For installations in Massachusetts, the Commonwealth of Massachusetts Plumbing Code 248 CMR shall be adhered to. Consult your
licensed plumber for installation of the system. This system and its installation must comply with state and local regulations.
Part Number
EV3114-09
EV3114-09
EV3114-07
EV3114-07
ADEQUATE
INLET PRESSURE
2. Open flushing valve to relieve
pressure.
3. Hold head firmly, push upward.
Turn cartridge to left until it stops.
LOW
OUTLET PRESSURE
4. Pull cartridge downward and out
of head.
5. Hold head firmly. Align cartridge
lug with label. Insert new car-
tridge firmly into head.
System Tested and Certified by NSF
International against NSF/ANSI Standard 42
and 53 for the reduction of:
Standard No. 42: Aesthetic Effects
Chemical Reduction Unit
Taste and Odor Reduction
Chlorine Reduction
Mechanical Filtration Unit
Particulate Reduction, Class I:
99.9+% reduction of particles
one-half micron and larger in size
Standard No. 53: Health Effects
Mechanical Filtration Unit
(MC, MH, XC, 7K Plus, XK Plus only)
Turbidity Reduction
Cyst Reduction
Asbestos Reduction
ADEQUATE
OUTLET PRESSURE
6. Turn cartridge right 90° until ro-
tation stops.
7. Repeat steps 3-6 for cartridges
2, 3 and 4, if applicable.
Flushing
8. With flushing valve fully open,
open inlet water at full force for five
minutes. Close flushing valve.
9. Turn on power to equipment.
Advertisement
