• All matters arising, which relate to the safety of this product, should be reported immediately in writing, giving full details, to the Product Safety Officer at e2v technologies. ENVIRONMENTAL: • e2v technologies declares that the Argus...
4 is the latest generation of the Argus Thermal Imaging Camera (TIC) from e2v technologies. With over 25 years experience in fire-fighters’ thermal imaging, e2v technologies continues to produce high quality, affordable systems designed for fire and heat detection for use with civilian, industrial and military rescue services.
Page 8
• SceneSave Image Capture Up to 100 images can be captured and stored in the Argus These images can then be viewed or deleted using the remote control or software provided. See section 2 for details of remote control. Using the software provided, captured images can be downloaded to a suitable laptop/PC in several formats.
Page 9
Extended Low Sensitivity mode, indicated by a red “M” symbol, and allows an image to be produced that is clear and will show some detail. The temperature range for this mode is up to around 800 °C (1472 °F). (Argus HR320: 1000 °C; 1832 °F).
If the warning appears and if appropriate, turn the camera off and leave for five minutes. Turn the camera on and check if the warning symbol has disappeared. If the warning symbol is still present, or the symptoms return, contact e2v technologies.
Rechargeable Battery Pack The Argus 4 camera is supplied with two rechargeable battery packs. The rechargeable packs are designed to power an Argus 4 for 4 hours from a full charge and use Nickel Metal Hydride (Ni-MH) cells. The battery pack contains circuitry that monitors the cell’s temperature to ensure that maximum performance...
Shelf life is maximised by storage between 10 °C and 25 °C (50 °F and 77 °F). To maintain the accuracy of the battery charge indicator, e2v recommends that batteries be occasionally fully discharged in a camera before charging.
Due to the environment in which the camera is used, the user can replace certain parts. If any damage beyond these parts occurs, return the camera to e2v technologies or an authorised repair centre. Any attempt at repair by unauthorised personnel may cause serious damage...
• 15 minutes at 150 °C (302 °F) • 7 minutes at 260 °C (500 °F) • 5 minutes at 260 °C (500 °F) (Argus 4 HR320) • Minimum operating temperature is –10 °C (14 °F) Sealing - The camera is sealed to allow short-term immersion in...
It is expressly agreed that the Purchaser’s sole and exclusive remedy for breach of the above warranty, for any tortious conduct of e2v, or for any other cause of action, shall be the repair and/or replacement, at e2v’s option, of any equipment or parts thereof, that after examination by e2v are proven to be defective.