Mini Cooper Owner's Manual page 92

Mini coupe, mini roadster, mini convertible
Hide thumbs Also See for Cooper:
Table of Contents

Advertisement

Technology for driving comfort and safety
Continued driving with a flat tire
When driving with a damaged tire:
1.
Avoid sudden braking and steering
maneuvers.
2.
Do not exceed a speed of 50 mph/80 km/h.
3.
At the next opportunity, check the air
pressure in all four tires.
If the inflation pressure is correct in all four
tires, then the Tire Pressure Monitor may not
have been reset. The system must then be
reset.
Possible driving distance with complete loss of
tire inflation pressure:
The distance it is possible to drive with a flat tire
depends on the load and the stress on the vehi-
cle while driving.
With an average load, it may be possible to drive
for approx. 50 miles/80 km.
When driving with damaged tires, the handling
characteristics change, e.g. the vehicle will skid
sooner when braking, braking distances will be
longer, or self-steering response will change.
Adapt your driving style accordingly. Avoid turn-
ing abruptly and driving over obstacles such as
curbs, potholes, etc.
Since the possible driving distance depends to a
considerable degree on the strain exerted on
the vehicle while driving, it can be shorter or,
with a gentle driving style, can also be longer,
depending on the speed, road condition, exter-
nal temperature, vehicle load, etc.
Drive cautiously and do not exceed a
speed of 50 mph/80 km/h.
A loss of tire inflation pressure results in a change
in the handling characteristics, e.g. reduced lane
stability during braking, a longer braking dis-
tance and altered self-steering
Vibrations or loud noises while driving can
indicate complete failure of the tire.
Reduce your speed and bring the vehicle to a
stop; otherwise, pieces of tire may come off,
which could result in an accident. Do not con-
tinue driving and contact your MINI
Online Edition for Part no. 01 40 2 904 077 - © 03/12 BMW AG
Malfunction
shown in gray and a message appears.
No punctures can be detected.
Display in the following situations:
>
>
>
shown in gray and a message appears.
No punctures can be detected.
Display in the following situation:
>
Message for unsuccessful system reset
The system has detected a wheel change, but
has not yet been reset. It is not possible to
provide a reliable warning about the current
inflation pressure.
Check the tire inflation pressure and reset the
properties.<
system, page 90.
dealer.<
The small warning lamp flashes in yel-
low and then lights up continuously; the
larger warning lamp lights up in yellow.
On the onboard computer, the tires are
Wheel without TPM electronics is mounted:
If need be, have it checked by your MINI
dealer.
Malfunction:
Have the system checked.
TPM was unable to complete the resetting
procedure; reset the system again.
The small warning lamp flashes in yel-
low and then lights up continuously; the
larger warning lamp lights up in yellow.
On the onboard computer, the tires are
Malfunction because of other equipment or
devices, same radio frequency:
After leaving the interference area, the
system is again active automatically.
Yellow warning lamp comes on. A
message appears on the onboard
computer.
CONTROLS
91

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

John cooper worksJohn cooperWorksCooper s

Table of Contents