Kenwood KTC-D600E Instruction Manual page 17

Installing the Remote Control Sensor
Paste the remote control sensor to the dashboard.
1
Remove the paper from double-stick tape and paste
it on the back of the remote control sensor.
2
Wipe the dirt and oil off from the installation area
and paste the remote control sensor
dashboard.
Remote control sensor 
• Wipe oil and dirt off from the installation surface.
• Avoid area where there is direct sunlight or close to TV
monitor because the remote control signals may be
affected.
Inserting CA Card and CAM
Insert the CA card (Conditional Access card) and CAM
(Conditional Access Module) into the card slot.
to the

• CA card (Conditional Access card) and CAM (Conditional
• When CA card and CAM are inserted in this unit, CA card
• When you insert or draw out a CA card and CAM in the
• When you insert or draw out a CA card and CAM, keep it
• Eject or insert the CA card or CA module before turning
• Do not leave this device inside the car. The temperature
Access Module) is optional (sold separately).
and CAM protrude from a unit. Take well care about an
installation position.
slot of this unit, be sure to ACC OFF.
horizontally.
on the power.
inside the car may rise rapidly, and CA card or other parts
may be deformed or become unusable due to the heat
inside the car.
There is also the danger of theft.
English 17