Advertisement
Connections
1.)
Run 4-Conductor speaker cable
from the amplifier (positive and
negative for both the left and right
channel) to the volume control -
marked and . Similarly, run 2-
conductor speaker cable from each
of the first pair of speakers to the
volume control. Label the cables for
future reference.
2.)
Measure the depth of the
volume control to make sure your
Volume Control will fit in the j-box.
3.)
Connect the speaker cable to the volume control:
a.
Strip ¼" of insulation from the end of each cable
b.
Tightly twist the wires in each cable until there are no frayed ends.
c.
Insert the 4-conductor speaker cable from the amplifier into the input
terminals.
d.
Insert the two 2-conductor speaker cables from the first pair of
speakers into the output terminals.
4.)
Connect additional speakers in parallel.
5.)
Make sure that all connections between your amplifier and the volume
control, and between the volume control () and each speaker, are in
"phase", that is (+) to (+) and (-) to (-).
6.) Adjust impedance using the Ohm Selector () (note: if you do not know
what this is, leave in the default position.)
6.)
Turn the volume knob to the "off" position (all the way down.)
7.)
Screw J-box into place
8.) Put on faceplate and screw in place using the screws ().
Advertisement
