Characteristics; Installation Of Water Dispenser; Installation Of Filter Bottle - Water Well D55 User Manual

- WARNING: Hot water can reach 95˚C, supervision is advised for young
children and persons without sufficient knowledge of the workings of the
water dispenser
- Do not tilt the water dispenser beyond 45˚ always keep upright
- Ensure the water dispenser is on a flat surface and placed at least
15cm from the wall.
- WARNING - Keep the water dispenser well ventilated if placed in an
enclosed area
- Unplug the water dispenser from the wall socket and drain all the
water from the water dispenser if the water dispenser is not in use for
a long time.
- Clean your water dispenser before use, if it has not been used for a
long period, discard the water from the hot & cold water taps, before
drinking.
- WARNING - Do not damage the thermostat
CAUTION: Plastic bags can be dangerous. To avoid danger of
suffocation, keep this bag away from babies and
children.

Characteristics

1. The Water Well water dispensers are energy efficient and emit
very little noise.
2. All the components of the water dispenser are made of high grade
materials and the design is firm and durable
3. The unit keeps the water within a certain temperature range. Hot
water will fluctuate betweent 85˚C - 95˚C, the cold water will
fluctuate between 6˚C - 10˚C, this is your optimum temperature
range within an ambient surrounding temperature range of
10 ˚C - 38 ˚C
2
4. The water dispenser uses a compressor system to heat and cool
the water, using 13V when the system is heating the water and 5V
when cooling the water.
5. The Water dispener can be used with either a Standard Water
bottle or a fitration bottle.
Installation of the Water Dispenser
1. Remove the water dispenser from its packaging
2. Place in an upright position away from direct heat or sunlight
3. Once you have inserted your water bottle (see sections 4 & 5) allow
the water to filter into the water dispenser.
4. Disguard the first few litres of water from both the cold and hot water
taps to eliminate any dust and dirt which may be in the unit
5. Once water has filled the reservoir tanks and is flowing out of both
the hot and cold water taps in the water dispenser, plug the water
dispenser into a wall socket and turn on the cold water switch first
and then the hot water switch on the back of the water dispenser
6. Allow the water dispenser to stand for awhile to reach the optimum
water temperature.
Installation of a Filter Bottle
Bottle Support
Image 2
Image 1
1. Remove the Bottle Support from the water dispenser by twisting the
Bottle Support to the left and lifting out of the water dispenser.
See Images 1 -3
Image 3
3