Table of Contents
Advertisement
7
Troubleshooting
This is a guide to the general symptoms, problems, and solutions that may occur during the
usage of your enclosure. However, it is important to remember that problems may occur within
the projector itself and these must also be considered.
Projector does not have power.
Check power supply wiring and voltage.
Fan is not spinning
Fan cords may have become disconnected. Check connections between fan and cord.
Fan may be obstructed. Shut off power to enclosure and check for obstructions. Turn power back
on to see if fan will start spinning. If fan does not turn then enclosure is not receiving power.
Turn off all power and check wiring. If the wiring is correct, contact technical support.
Projector does not have power.
Check projector power switch. If switch is on, check wiring and supply switch/circuit breaker.
Projector turns on and off repeatedly over short span of time.
Check that vent areas and airways are clear. If so, ambient temperature may be too high, or
projector may have internal problem.
Excessive water in enclosure.
Glass seal leak. Repair with silicone sealant.
Door gaskets leak caused by separation. Silicone piece back into place or replace section.
Blizzard Enclosure User Manual
page 33
Advertisement
Table of Contents
