Unpacking And Assembly; Ventilation; Connecting Heater To Lp Cylinder - Remington HH-18-PCH User's Manual And Operating Instructions

NEVER LEAVE HEATER
UNATTENDED WHILE BURN-
ING OR WHILE CONNECTED
TO A FUEL SOURCE
Features
Safety
Guard
Front
Castor
Figure 1. Product Features

Unpacking and Assembly

- Remove heater and base from Carton (Save carton and
packing materials for later storage).
- Remove all protective packaging protecting heater dur-
ing shipping.
- Place Heater Base on flat surface with wheels on
ground.
- Line up holes in bottom of heater cabinet with locking
tabs on top of base (see Figure 2)..
- Mount heater cabinet to heater base sliding tabs
through holes in bottom of cabinet and sliding cabinet
backward approximately ¼" or until cabinet will not
move further back.
- Use thumbscrews to attached heater cabinet to heater
base.
- Inspect heater closely for any damage that may have
occurred during shipping. If there is any damage, return
the heater to the place of purchase.

Ventilation

Caution:
Always provide a fresh air opening in the heat-
ed space of at least three square feet (2,800 sq. cm) for
each 100,000 BTU/Hr. of heater output. Provide a larger
opening if more heaters are being used. As an example, a
HH-18-PCH heater will require:
WARNING! This heater is not intended for residential use.
Page 4
Pinnacle Products International, Inc. Propane Cabinet Heater User's Manual
- a two-car garage door open 2 inches, or
Valve Knob
- a single car garage open 3 inches, or
- two thirty two inch wide windows open 4 inches.
Connecting to Gas Supply
IMPORTANT! Always use a propane (LP) cylinder that has
Handle
a connection device that is compatible with the hose and
Slot
regulator assembly supplied.
Back
CAUTION
Cover
plied with the heater must be used without alteration.
CAUTION
frayed, replace it with the manufacturer suggested
assembly.
Rear
- Remove the Back Cover by sliding the cover straight up
Castor
and away from the Heater Body. Place the LP cylinder
on the Bottom Plate and replace the Back Cover.
Figure 2. Removing/Replacing Bottom Plate
- To connect LP cylinder, insert regulator end fitting into
cylinder valve, rotate coupling nut clockwise and tighten
firmly (see Figure 3).
Figure 3. Connecting Hose/Regulator to LP cylinder
®
Cabinet Heaters
The Propane (LP) gas pressure
regulator and hose assembly sup-
Be sure to inspect the regulator hose
before each use. If the hose is cut or
Regulator
Coupling Nut
Propane