Aux; Sleep Timer; Reset; System Settings - LENCO BT-4304 User Manual

 Mute button, press this button to turn off the volume, press it again to turn on the
volume.

AUX

Use the AUX connection to connect an external audio source. Press AUX on the
main unit or on the remote control to enter AUX mode. When AUX mode is active you
can only use the volume controls of the Lenco device all other functions need to be
operated from the device that send the signal to the Lenco device.

Sleep timer

This feature will turn off the device after a preset amount of time (Up to 90 minutes).
To activate the sleep timer mode press the
until the desired time is reached. You can choose out of 15, 30, 45, 60 and 90
minutes. Take note that the sleep timer doesn't turn off the external audio device.

Reset

If the device does not respond to the control buttons anymore, press the reset button
to reset the device. The reset clears the system memory so all settings will be
erased.

System settings

Setting the display backlight level

Press the dimmer button on the remote control to adjust the backlight intensity. The
intensity can be set low or high.

Setting the clock

1. Press the 12 / 24 hour button on the remote control to set the desired clock
format.
2. Press the set clock button on the remote control to enter time set mode.
3. Press the HR button on the remote control to set the hours.
4. Press the MIN button on the remote control to set the minutes.

Troubleshooting

Problem
Unit does not turn on
No sound
Remote control does not function
Unit does not respond
button on the remote control repeatedly
Answer
Check if the adaptor is connected correctly
Did you select the right source (Bluetooth® of AUX)
Is the external audio source set correct?
Is the Bluetooth® device paired?
Press mute
Press volume +
Are you within the operating area?
In strong light (outdoor) the remote control may not
work properly.
Maybe the battery is empty?
Reset the unit.