Aeware in.tune User Manual page 30

installation & connections
Mounting surface
Template
Step 1
Using the drilling template supplied with the unit, determine the
mounting location and then stick the template on the location.
TOP
195 mm
Cut and remove the hatching area on the template. Then drill six
3/16" (5mm) mounting holes in the exact position according to the
Drill "
3/16
2 "
1/8
5 mm
54 mm
mounting paper.
30
Center line
7 "
11/16
7 "
3/16
183 mm
Drill
1 "
7/16
36 mm
Cut out gray area
Step 2
Insert the mounting sleeve into
the hole (installation opening).
"
3/16
5 mm
in.tune instructions
Step 3
If the installation location is
not perfectly even (e.g. wood
surface), make a silicone
joint between the installation
location and the mounting
sleeve (to avoid water leakage).
Apply silicone all around the
unit. Let the silicone dry and
remove excess.
Note: Failure to apply silicone
may damage the unit and
surround equipment!