Assembly And Operating Instructions - Coleman 300102 Owner's Manual

ASSEMBLY AND OPERATING INSTRUCTIONS

Surface Preparation
Before starting any cleaning task, it is important to inspect the area for objects that
could create a hazard. Remove any objects from the work area that could be tripped
over, such as toys or outdoor furniture. Ensure that all doors and windows are closed
tightly.
Water Supply (Cold Water Only)
Only draw water through the unit. For use with cold water supply only. Water hose
must be at least a 1/2" (13 mm) in diameter. Flow rate of water supply must not fall
below 2 US GPM (US gallons per minute) [7.6 LPM (litres per minute)]. Flow rate can
be determined by running the water for one minute into an empty 5-gallon (19 L)
container. The water supply temperature must not exceed 104°F (40°C).
CAUTION
• Never use the pressure washer to draw in water contaminated with solvents
(e.g. paint thinners, gasoline, oil, etc.).
• Dirt in the water inlet will damage the unit. To avoid this risk, we recommend checking
the water filter (located inside the water inlet. To clean it out, see Maintenance section).
• Always prevent debris from being drawn into the unit by using a clean water source
and an additional accessory water filter if required.
• To prolong the life of the unit, rest the unit for 5 minutes after every
30 minutes of use.
1
Attach high pressure hose to the
machine's water outlet (hand tighten
only)
2
Attach high-pressure hose to the gun
assembly (hand tighten only)
9
ASSEMBLY AND OPERATING INSTRUCTIONS
3
Recommendation for
spray tip usage:
Red
0°
For tough spots &
grimes (e.g. concrete
surface)
Yellow
15°
To clean larger areas
(e.g. drive way)
Black
Low pressure
To apply detergent
Attach desired colour coded spray tip to wand. Ensure it is clicked in securely. Insert
wand into the gun. Hand tighten only.
10