Tripp Lite SmartPro 2U Rackmount SMART1400RM2U Owner's Manual page 5

200212046 93-2107 SmartPro 2U Owner's Manual.qxd
Mounting
2-Post (Telecom) Installation
Mount the shelved sections (A) of your UPSRMRII kit
1
on the back side of your rack. Mount them in the lowest
available space of your rack with with the screws, nuts
and washers provided (B). Note that the support ledges
should face inward.
Attach mounting ears (C) to the front mounting holes of
2
your equipment (D) using the screws provided (E). The
ears should face backward.
Using an assistant if necessary, lift your equipment
3
and slide it onto the mounting shelves. Attach your
equipment to the rack by passing the screws, nuts and
washers provided (F) through its mounting ears and
into the rack rails.
Color Selection
Select UPS systems can be configured to match black or grey equipment. To match grey equipment,
mount the grey mounting ears in front. To match black equipment, switch the grey front panel on the
unit for the black front panel (included with select models), and mount the black mounting ears in
front. (See mounting instructions for exact mounting ear placement.)
To switch the front panel of the UPS, first unscrew the six screws on the front face of the unit, then
remove the front panel. Next, unscrew the two screws that attach the LED board to the inside of the
front panel, then remove the LED board without disconnecting the ribbon cable that connects it to
the UPS. Screw the LED board to the new front face and screw the new front face to the UPS.
1/6/2003 2:22 PM
B
1
D
2
F
3
5
Page 5
A
C
E