Sony Bravia KDL-55W900A I-Manual page 37

content with 3D signals). Select [Auto(High)] to always optimize to a
visually comfortable depth. Select [Auto(Low)] to provide a visually
comfortable depth which is close to the original picture. You can also
manually set the adjustment value.
[Simulated 3D Effect]
Heightens/lessens the 3D effect when you display 2D pictures in
simulated 3D.
[3D Glasses Brightness]
Sets the image brightness when using 3D display mode. By selecting
[Auto], image brightness through the Active 3D Glasses is automatically
adjusted in conjunction with the [Picture Mode] setting.
[Auto 3D]
Select [Auto 1] to switch 3D display mode automatically when a 3D
signal is detected.
If no 3D signal is detected, select [Auto 2], which will analyze the image
for 3D information and switch to 3D display mode automatically.
Select [Off] to prevent 3D display mode from being automatically
selected.
Depending on the input signal or format, 3D display mode may not
switch automatically.
In such a case, press the 3D button to select 3D display mode manually.
[3D Signal Notification]
Notifies when a 3D signal is detected.
To replace the battery
If the LED indicates low battery power (indicator blinks green (yellow
when SimulView™ mode) 3 times every 2 seconds), replace the battery.
Use a CR2025 battery only. Press the unlock button with the tip of a
pen, etc, and take out the battery case, then replace the battery with a
new one. After that, be sure to lock the battery case again.
Tips
If you wear glasses, remove the nose pad of the Active 3D Glasses by
pulling it down, then wear them over your glasses.
Notes
37