Service Miscellaneous; Using Booster Battery; Replacing Fuse - Great Dane GSRKA1934S Operator's Manual

cover (C).
7. Connect negative (-) battery cable (B) and install cover
(A).
Cleaning Battery and Terminals
1. Park machine safely. (See Parking Safely in the
SAFETY section.)
2. Disconnect and remove battery.
3. Wash battery with solution of four tablespoons of bak-
ing soda to one gallon of water. Be careful not to get
the soda solution into the cells.
4. Rinse the battery with plain water and dry.
5. Clean terminals and battery cable ends with wire brush
until bright.
6. Apply general purpose grease or silicone spray to ter-
minal to prevent corrosion.
7. Install battery.

Using Booster Battery

CAUTION: Avoid injury! The battery produces
a flammable and explosive gas. The battery
may explode:
• Do not smoke or have open flame near battery.
• Wear eye protection and gloves.
• Do not jump start or charge a frozen battery.
Warm battery to 16°C (60°F).
• Do not connect the negative (-) booster cable
to the negative (-) terminal of the discharged
battery. Connect at a good ground location
away from the discharged battery.
A
A - Booster Battery
B - Disabled Vehicle Battery

SERVICE MISCELLANEOUS

B
SERVICE MISCELLANEOUS - 33
1. Connect positive (+) booster cable to booster battery
(A) positive (+) post (C).
2. Connect the other end of positive (+) booster cable to
the disabled vehicle battery (B) positive (+) post (D).
3. Connect negative (–) booster cable to booster battery
negative (–) post (E).
IMPORTANT: Avoid Damage! Electric charge from
booster battery can damage machine components. Do
not install negative booster cable to machine frame.
Install only to the engine block.
Install negative booster cable away from moving parts in
the engine compartment, such as belts and fan blades.
4. Connect the other end (F) of negative (–) booster cable
to a metal part of the disabled machine engine block
away from battery.
5. Start the engine of the disabled machine and run ma-
chine for several minutes.
6. Carefully disconnect the booster cables in the exact
reverse order: negative cable first and then the positive
cable.

Replacing Fuse

The electric start circuit is protected by one 20 Amp fuse.
IMPORTANT: Avoid Damage! Help prevent machine
circuit damage. Make sure replacement fuse is the
correct size.
1. Locate electric start fuse holder under console on the
machine.
• Open fuse holder (A) and remove socket with fuse.
• Check metal clip in fuse window. Discard fuse if clip is
broken.
• Install new 20 Amp fuse in socket.
• Install socket with fuse in cover. Ensure that plastic tab
�