Frame Diagrams Main Menu /Power UP/Previous Down/Next Exit/stop Right/Volume Up Left/Volume Down Enter/Pause Remark: Press and hold the Power button for 3 seconds to turn the device into Standby mode. Press the Power button again to re-activate the digital photo frame.
Remote Control Installation Insert the jack of the DC adapter into the digital photo frame, and then plug the DC adapter into a standard power outlet. Your frame will start up automatically. Main Menu 1. Memory Select (Exhibit 1) Press Menu on remote control or Menu on backside button to go to the Memory selection interface.
Internal Memory SD/SDHC/MMC USB stick 3.1 Photo Display Choose Photo icon, press [ENTER] on remote control, it will play picture the slideshow automatically on the screen. During photo slideshow, press [ENTER] go to different modes “Browse Mode” or “Slideshow”.
3.3 Video Display Choose Video icon, p ress [][] to choose one video and press ENTER to display video. (as shown below). Press [ENTER] on remote control or ENTER on device to activate and stop video during video display.
3.6 Setting Select the setting icon or instead press the SETUP key on the remote control to setup your frame. (as shown below) Operation method [][] button to shift items or choose parameters []/[] button to change the parameters. ...
Auto Power off On/Off Auto Shut Time Set auto shut time, Hour/minute Auto-Power Frequency Once/ Everyday/ Mon. to Fri. /Weekend Volume Volume adjustable Reset default setting Restore to the factory settings Version Show the software version System Upgrade Software firmware update (if available) * The above settings are subject to change in case of any spec modification Frequently Asked Questions Q.