Introduction; Introduction And Notices - CompuSTAR Drone Mobile DR-1000 Install Manual

Install Guide

Introduction and Notices

Welcome to the DroneMobile installation manual. This manual is intended for experienced installers only. We highly recommend that you
contact your local DroneMobile dealer and seek professional installation. Call 888-820-3690 or visit our website at www.dronemobile.com
for more information.
Please observe the following guidelines when installing this system:
• Do not use the battery backup port on the CM5 or CM6 Series control modules to power the DR-1000. It does not provide enough
current. Use a power supply that can support up to 2 amps of current draw.
• We recommend using relays for DroneMobile outputs. All inputs require relays if inverting the polarity.
• Relays are not required for the RS232 data connection. Please use the included Serial Port Adapter for this connection.
• A Firstech remote start system MUST be installed to utilize all DroneMobile features. DroneMobile may be used with an aftermarket
remote start.
• We recommend mounting the DR-1000 horizontally. Do not install under metal panels as that will hinder GPS and/or cellular signal.
Once installation is complete do not connect the plugs into the DR-1000. First activate and register your DroneMobile online at www.
dronemobile.com and wait for the SIM status to change to "Active." DroneMobile carries a 1 year manufacturer's warranty.
Firstech, LLC. does not condone or recommend
installing DR-1000 on a vehicle with a fuel
or ignition interrupt. Doing so may result in
damage to the vehicle and/or injury to driver.
Please use a digital multimeter to test all wires.
Firstech, LLC. will not assume any
responsibility for improper use and/or
installation. For Terms and Conditions refer to
www.dronemobile.com/usersmanuals

Introduction

Copyright 2010 Firstech, LLC. | 2