RangeMax Wireless Router WPN824v3 User Manual
3. Click Add or Edit. The following screen displays:
Figure 5-8
4. Enter the settings for the static route.
•
Route Name. This is for identification purposes only.
•
Private. If you want to limit access to the LAN only, then select this check box. The static
route will not be reported in RIP.
•
Active. You must select this check box to make this route effective.
•
Destination IP Address. The IP address of the final destination.
•
IP Subnet Mask. If the destination is a single host, type 255.255.255.255.
•
Gateway IP Address. This must be a router on the same LAN segment as your wireless
router.
•
Metric. Type a number between 2 and 15. This represents the number of routers between
your network and the destination. Usually, a setting of 2 or 3 works, but if this is a direct
connection, set it to 2.
5. Click Apply. The static route is added to the Static Routes table.
5-14
v1.0, January 2008
Advanced Settings and Features