Filling The Water Reservoir - Gevalia C84-3A User Manual

IMPORTANT:

FILLING THE WATER RESERVOIR:

Open the hinged Water Reservoir Lid that is located on the top backside of the
Coffeemaker (See Figure A). Fill the Water Reservoir with the desired amount of cold
filtered or bottled water. Refer to the markings on the side of the Water Level Indicator to
see how much water is inside it. Do not exceed the MAX Fill Line indicated on the Water
Reservoir.
NOTE:

There is an Overflow Hole in the back of the Water Reservoir to prevent
exceeding the capacity of the Coffeemaker. If you add too much water, it will
drip out from the back of the unit.

The amount of brewed coffee after the brewing process will always be slightly
less than the amount of water placed into the Coffeemaker, since some water
will be absorbed by the coffee grounds.
SETTING YOUR CLOCK AND USING THE PROGRAMMABLE TIMER:
Auto Light
Hour Button
Minute Button
Figure B
SETTING YOUR CLOCK:
To set the hour: Press the HOUR button repeatedly until desired hour is set.
Note: Be sure to check that the AM/PM indicator, located in the left side of the
digital clock display, is also set to the correct time of day.
To set the minutes: Press the MIN button repeatedly until desired minutes are set.
NOTE: Unplugging the unit will reset the clock to 12:00.
SETTING YOUR PROGRAMMABLE TIMER:
Hold down the PROGRAM button.
Use only cold filtered or bottled water for best results.
Clock/Timer
Digital Display
-6-
On Light
On/Auto/Off Button
Program Button