Toyota Solara 2004 Operating Manual page 22

LOCKING AND UNLOCKING
POWER DOOR LOCK SWITCH
Push the switch.
To lock: Push the switch down on the
front side.
To unlock: Push the switch down on the
rear side.
Operating the switch simultaneously locks
or unlocks both doors.
If you do either of the following, no door
can be unlocked with the power door lock
switch.
D
Lock both doors with the key or wire-
less remote control transmitter when
both doors are closed.
D
Open the driver's door or passenger's
door and move the inside lock knobs
of both doors to the lock position, then
close the doors.
The power door lock switch can be reset
in the following ways.
D
Turn the ignition key to "ON".
D
Unlock both doors with the key or wire-
less remote control transmitter.
D
Unlock the driver's door or passenger's
door with the inside lock knob, and
then unlock both doors with the power
door lock switch.
22
'04 Solara_U (L/O 0402)
—Automatic door locking and
unlocking functions
WITH You can set the following auto door
locking and unlocking functions.
(a) Locking linked with the shift posi-
tion (with automatic transmission
only)
Both doors are locked automatically when
the selector lever is moved out of the "P"
position with the engine running.
This function is the default setting for new
vehicles.
(b) Unlocking linked with the shift posi-
tion (with automatic transmission
only)
Both doors are unlocked automatically
when the selector lever is moved to the
"P" position with the ignition switch in the
"ON" position.
(c) Unlocking linked with opening the
driver's door
Both doors are unlocked automatically
when the driver's door is opened within 10
seconds after the ignition switch is turned
from "ON" to the "ACC" or "LOCK" posi-
tion.
Setting the functions
1. Close both doors.
2. Turn the ignition switch to the "ON"
position.
3. Within 10 seconds after the ignition
switch is turned to the "ON" position;
D
To set function (a)
Push and hold the front of the power
door lock switch for 5 seconds with the
selector lever in the "P" position.
D
To set function (b)
Push and hold the rear of the power
door lock switch for 5 seconds with the
selector lever in the "P" position.
D
To set function (c)
Push and hold the rear of the power
door lock switch for 5 seconds with the
selector lever in any position except
"P".
Both doors automatically lock and unlock
when you release the power door lock
switch. This indicates that the function is
set. If both doors do not lock and unlock,
the time the switch was held may have
been too short or too long. Perform the
procedure over again starting from step 1.
2004 SOLARA from Feb. '04 Prod. (OM33640U)