Graco 245095 Repair Manual page 16

e. Twist latch u-bolt back from pump door outer edge
f. Place u-bolt on pump door protrusion
F . 16
IG
8. Ratchet pump door forward.
F . 17
IG
9. Open pump door.
F . 18
IG
10. F . 19. Pull out pump pin and place in pin holder
IG
F . 19
IG
16
Installation
1. F . 20. Adjust piston rod with pin holder to pull out piston
IG
rod. Tap piston rod on hard surface to push in piston rod.
2. Push pump collar flush with bearing housing ledge to be
able to close pump door.
F . 20
IG
3. F . 21. Slide pump into connecting rod. Push pump pin until it
IG
is fully retained.
Note: Pin will snap into position.
F . 21
IG
4. F . 22. Close pump door and rotate latch into position.
IG
Do not tighten latch.
Displacement Pump
32 a
3 a
311046J