Electronic Specifications / Mechanical Specifications / Environmental Specifications; Ev-G200C1/Ev-G200B1 - Ricoh EV-G030B1 Specifications

Gige vision extended-depth-of-field camera
Table of Contents

Advertisement

1.2

Electronic specifications / Mechanical specifications / Environmental specifications

EV-G200C1/EV-G200B1

Product
Electronic
Imager
specifications
Total picture elements
Active picture elements
Chip size
Cell size
Scanning system
Vertical frequency (Frame rate)
Horizontal frequency
Pixel frequency
Noise level
Minimum scene illumination
Sync. System
Video output
Interface
Protocol
Exposure time
ALC
Gain
Gamma
AOI function
Smear reduction
Color interpolation
White Balance function
Trigger mode
Communication
I/O's
Auto IRIS lens control
Power
Mechanical
Dimensions
specifications
Optical filter
Optical center accuracy
Material
Lens mount
Connectors
Camera mount screws
Weight
Environmental
Operational
specifications
Storage temerature
Vibration
Shock
Standard compliancy
RoHS
EV-G030B1 / EV-G200C1 / EV-G200B1
Specifications Rev. 1.00
1/1.8" interline UXGA color
progressive CCD: ICX274AQ
*EV-G200B1: With respect to the entered size, the 15 pixels above and below, and the 0 to 14th pixels and 1609th
*EV-G200C1: RAW data: With respect to the entered size, the 19 pixels above and below, and the 0 to 18th
RGb 8bit: With respect to the entered size, the 18 pixels above and below, and the 0 to 17th pixels and 1604th to
Additionally, the 2 pixels above and below, the 18th,19th, 1602nd, and 1603rd pixels within the blackened area will
Maximum frame rate of the camera (61.26674 Hz) is 230 vertical resolution AOI setting
at 8bit output
at 10bit output
at 12bit output
7.27 Lux at F1.2, 15.31668Hz
Digital 8, 10 or 12 bit Raw or RGB 8 bi
Auto, manual and push to set white balance
is available on both Raw data output and RGB output
Input voltage
Consumption
Lower limit
Higher limit
Camera housing temperature (Top plate): 70 deg. C (Check "Operational temperature and power consumption")
EV-G200C1
1688 (H) x 1246 (V)
to 1623rd pixels on the left and right sides will be blacked out.
pixels and 1605th to 1623rd pixels on the left and right sides will be blacked out.
1623rd pixels on the left and right sides will be blacked out.
be invalid (it is recommended that this area not be used for testing).
8.5 (H) x 6.8 (V) mm
4.4 (H) x 4.4 (V) µm
Progressive
15.31668 Hz at full resolution
0.29261 to 61.26674 Hz changeable via the communication
Maximum frame rate is depending on the AOI setting
19.176 kHz
36.818175 MHz
<= 3 Digit (Gain 0 dB)
<= 12 Digit (Gain 0 dB)
<= 48 Digit (Gain 0 dB)
PoE : IEEE802.3af CLASS3 (1000BASE-T)
GigE Vision 1.2 and GenICam 2.0 compliant
Preset continuous mode: 10 useconds to 16,777,216 useconds
Preset trigger mode: 10 useconds to 16,777,216 useconds
Pulse width mode: 10 useconds to Unlimited
Auto iris lens, electronic iris and AGC (ON/OFF)
0 to 20.4 dB
Gamma 1.0 (Factory default) or downloadable gamma table
Programmable AOI setting via the communication
Selectable ON/OFF via the communication
Available on RGB output
Edge preset trigger, pulse width trigger (unlimited long exposure)
UART communication through Ethernet port
Three opt isolated inputs and five opt isolated outputs
Not available
+10.8 to +26.4Vdc through power/IO connector or Power Over Ethernet
(Auto detection with power/IO connector prioritized)
Less than 6.8 W
50 (H) x 50 (W) x 53.5 (D) mm excluding connectors
IR cut filter on
Positional accuracy in H and V directions: +/- 0.3 mm
Rotational accuracy of Ha nd V: +/- 1.5 deg.
Aluminum (AC)
RJ45 connecor
Power/IO connector: HR10A-10R-12PB (Hirose) or equivalent
DC IRIS lens connector: M1951 (EMUDEN) or equivalent
Two 1/4" Tripod screw holes (one each on top and bottom plate)
Sixteen M4 screw holes (four each on top, bottom and both sides plate)
Approximately 170 g
Environmental temperature -5 deg. C
Environmental temperature -30 to 65 deg. C
20Hz to 200Hz to 20Hz (5min./cycle), acceleration 10G, 3 directions 30 min. each
Acceleration 38G, half amplitude 6ms, 3 directions 3times each
EMS: EN61000-6-2, EMI: EN55011 Group 1 Class A
/ FCC 47CFR Part 15 Subpart B Class A(Verification) / ICES-003(Class A)
RoHS compliant
EV-G200B1
1/1.8" interline UXGA monochrome
progressive CCD: ICX274AL
UXGA: 1624 (H) x 1236 (V)
0.16 Lux at F1.2, 15.31668Hz
Internal
Digital 8, 10 or 12 bit Raw data
Not available
Not available
No filter
C mount
6

Advertisement

Table of Contents
loading

This manual is also suitable for:

Ev-g200c1Ev-g200b1

Table of Contents