Kenwood KDC-361U Instruction Manual page 14

Warning
Caution
Basic procedure
1 Remove the key from the ignition switch, then
disconnect the terminal of the car battery.
2
Connect the wires properly.
See Wiring connection.
3
Install the unit to your car.
See Installing the unit (in-dash mounting).
4 Connect the terminal of the car battery.
5
Reset the unit.
12
Installing the unit (in-dash mounting)
How to remove the unit
1
Detach the faceplate.
2
Fit the catch pin on the extraction
keys into the holes on both sides of
the trim plate, then pull it out.
3
Insert the extraction keys deeply into
the slots on each side, then follow the
arrows as shown on the right.