Table of Contents
Advertisement
Beep Codes
3. Replace the keyboard.
If you have the network drivers installed, but do not have the AlphaPC
Note:
164UX connected to a network, there will be a noticable increase in the
time it takes for NT to start-up after the login. This is caused by the net-
work drivers having to wait for a time out.
8.2 Beep Codes
The beep codes provide error information about the AlphaPC 164UX system. Table
8–1 lists and describes the beep codes.
Table 8–1 Beep Codes
Beep Code
1 Very long beep
1 Long, 1 short
1 Long, 2 short
1 Long, 3 short
1 Long, 4 short
1 Long, 5 short
1 Long, 6 short
1 Long, 7 short
1 Long, 8 short
1 Long, 9 short
2 Long, 1 short
2 Long, 2 short
3 Long
4 Long
Continuous
8.3 Post Codes
The post codes indicate the progress of the SROM and the ARCSBIOS firmware.
Table 8–2 lists and describes the post codes.
Troubleshooting
8–2
Description
No Fan. Shut down the system immediately.
Cannot measure CPU speed.
Invalid DIMM configuration
Cached Memory Error
Noncached Memory Error
SROM had bad checksum
PAL has bad checksum
Error copying FLASH to memory.Failed noncached verify
Error copying FLASH to memory.Failed refill from DIMM verify
Error copying FLASH to memory.Failed refill from Bcache verify
ARCSBIOS has bad checksum, will boot safe ARCSBIOS.
Safe ARCSBIOS has bad checksum
No video
No keyboard
No Fan,shut down system immediately
Advertisement
Table of Contents
