Advertisement
Changing the battery
When the CHECK indicator goes dim or no
longer lights while an effect is on, it means
that the battery is nearly dead and must be
replaced.
Replace the battery following the steps be-
low.
Battery Snap Cord
Battery Snap
9V Battery
1. Loosen the thumbscrew at the front of the
2. Remove the old battery from the battery
Thumbscrew
Pedal
Spring Base
3. Connect the battery snap to the new bat-
Coil Spring
Guide
Bush
4. Slip the coil spring onto the spring base on
Hole
Battery
Housing
5. Finally, insert the thumbscrew into the
pedal, then lift the pedal upwards to open
the unit.
* The thumbscrew can be left in the pedal
while changing the battery.
housing, and remove the battery snap con-
nected to it.
tery, and place the battery inside the bat-
tery housing.
* Be sure to carefully observe the battery's
polarity (+ versus -).
the back of the pedal, then close the pedal.
* Carefully avoid getting the snap cord
caught in the coil spring.
guide bush hole and fasten it securely.
23
Advertisement
