Aluratek ABTK01F User Manual

Bluetooth Folio Case with Removable
Keyboard for iPad 1, 2, 3 & 4th Generation

Charging the battery

The battery is not fully charged and it is highly recommended that you charge ABTK01F before you begin using it.
Note: Using ABTK01F "out of the box" will not harm the device. You will experience reduced battery life as the unit will not be fully charged.
Connect the micro USB end of the USB cable provided to the keyboard and the other end of the USB cable to a
computer. Please charge the battery for a minimum of 4 hours. The red LED will be on while charging. When
charging is complete, the green LED will turn on.

Pairing ABTK01F with your iPad

1. Make sure ABTK01F is turned on by sliding the power switch to ON.
The blue LED will flash once.
2. Activate ABTK01F pairing mode by pressing the button next to the
power switch. The blue LED will start to flash.
3. Activate your iPad's Bluetooth function by going to Settings > General >
Bluetooth > ON. Select "ABTK01F" when it is found.
4. Please enter the 4 digit PIN code shown on the iPad on the keyboard
and press "Enter". The blue LED will turn OFF.
5. The keyboard should be paired/connected and ready to use.
PAIRING
ON / OFF
LEDs
SWITCH