AEG ÖKO_FAVORIT 60800 User Instructions page 33

• If the dishwasher is installed under-
neath a kitchen work surface, the
original work surface of the dish-
washer is to be removed as follows:
– Unscrew the screws (1) from the
elbows on the back side.
– Slide the work surface approx.
1cm to the rear (3) , lift at the
front (4) and remove.
– Press the work surface retaining
brackets at the position shown in
the diagram (4) and remove the
bracket at an angle to the rear
(5).
• The dishwasher must also be screwed on tightly to the work surface
or to the adjoining units. This is essential to ensure the dishwasher
does not tip.
If the dishwasher is later used as a free-standing appliance, the original
1
work surface must be re-mounted.
3
The plinth on free-standing appliances is not adjustable.
Installation and Connection Instructions
4
5
33