Graco Angelcare 1750296 Owner's Manual page 16

Movement sensor with sound monitor
Table of Contents

Advertisement

Available languages

Available languages

Problem
Power Indicator (green light)
does not light up.
There is very weak reception.
There is static, distortion,
interference, etc.
There is feedback (squealing
noises).
Possible Cause
Batteries are low or improperly
installed.
AC adapters are not connected
properly or electrical outlet is
out of order.
One of the units is not on.
Parents' and Nursery Units are
too far apart.
One or both units are placed
near a large metal mass.
One or both units are not in the
upright position.
Batteries are low.
Parents' and Nursery Units are
too far apart.
Units are not set to the same
channel.
One of the units is not on.
The Parents' Unit is located near
motorized devices,
fluorescent lights, television, etc.
Units are too close to each other.
The volume is too high.
16
Solution
Check or replace batteries.
Check connections or change to
another electrical outlet.
Make sure both units are on the
same channel, either both on A or
B.
Bring Parents' Unit closer to
Nursery Unit.
Change the position of one or
both units.
Place units on flat surface away
from baby's reach.
Check or replace batteries.
Bring Parents' Unit closer to
Nursery Unit.
Make sure both units are on the
same channel, either both on A or
B.
Make sure both units are on.
Rotate Parents' Unit or move
it away from source of
interference.
Move units farther apart
(at least 10 feet apart).
Decrease volume on Parents'
Unit.

Advertisement

Table of Contents
loading

This manual is also suitable for:

Angelcare ac2012pAngelcare ispd026bbAngelcare

Table of Contents

Save PDF