FRONT PANEL controls and zero out your gains and master volume first. Package Contents: This package should contain- • TGA 2.1 Guitar Amplifier • FS-2 Footswitch • IEC Power Cable Warranty: The TGA 2.1 Guitar Amplifier is covered for 1 year parts and labor.
Demeter Amplification | TGA-2.1 User Guide Notes on use: The TGA-2.1 works like three amplifiers in one, but it’s important to note that the amp does this with 2 chan nels, eliminating the need for redundant controls, which makes dialing in your tone a snap. The TGA-2.1 is a two- channel amplifier, with two VARIATIONS of the second channel.
Page 4
Demeter Amplification | TGA-2.1 User Guide...
Page 5
Demeter Amplification | TGA-2.1 User Guide Front Panel Operation • Power/Standby Operation : When powering up any good tube amplifier, the POWER SWITCH should be engaged FIRST (pilot lights up) to warm up the power tubes. This is known as STANDBY mode. By letting power tubes warm up gradually, they last longer (more on power tubes later.) Wait anywhere from...
Page 6
Demeter Amplification | TGA-2.1 User Guide Rear Panel Operation • FS-2 Footswitch Jack : This is a TRS (Tip-Ring-Sleeve) type jack. Any 3-conductor cable with 1/4” TRS jacks will work for longer runs (e.g. unshielded headphone extension cable.) • Effects Loop Send/Return : SEND comes from the preamp of TGA-2.1 and goes to the input of your effects chain.
Page 7
Demeter Amplification | TGA-2.1 User Guide FS-2 Footswitch Operation The FS-2 Footswitch (included w/TGA- 2.1) selects any of the 3 major sections of the amp (clean, edge or solo). • Left footswitch : Toggles between Channel 1 (clean) and Channel 2 (edge/solo) • Right footswitch : Toggles between edge and solo when Channel 2 is engaged (has no effect when clean channel...
Need help?
Do you have a question about the TGA 2.1 and is the answer not in the manual?
Questions and answers