Electrical Connection - Electrolux EUF2949IOX User Manual

7.2 Location

7.3 Electrical Connection

CAUTION!
Any electrical work required to in-
stall this appliance should be car-
ried out by a qualified electrician
or competent person.
WARNING!
This appliance must be earthed.
The manufacturer declines any lia-
bility should these safety meas-
ures not be observed.
1
5
The wires in the mains lead are
coloured in accordance with the
following code:
To ensure best performance, if the appli-
50 mm
ance is positioned below an overhanging
wall unit, the minimum distance between
the top of the cabinet and the wall unit
must be at least 40 mm. Ideally, however,
the appliance should not be positioned
below overhanging wall units.
The ventilation space can be:
• directly above the appliance
• behind and above the top cupboard.
In this case, the space behind the top
cupboard must be at least 50 mm
deep.
1
Green and Yellow:
3
Brown:
5
Blue:
As the colours of the wires in the mains
lead of this appliance may not correspond
with the coloured markings identifying the
terminals in your plug, proceed as follows:
1. Connect the wire coloured green and
yellow to the terminal marked either
with the letter "E" or by the earth
symbol
low.
2
2.
Connect the wire coloured blue to the
terminal either marked with the letter
"N" or coloured black.
3. Connect the wire coloured brown to
the terminal either marked with the
"L" or coloured red.
4. Check that no cut, or stray strands of
wire is present and the cord clamp
is secure over the outer sheath.
5. Make sure the electricity supply volt-
age is the same as that indicated on
the appliance rating plate.
6.
Switch on the appliance.
3
The appliance is supplied with a 13 amp
plug fitted
4
change the fuse in the plug supplied, a 13
amp ASTA approved (BS 1362) fuse must
be used.
ENGLISH
Earth
Live
Neutral
or coloured green and yel-
2
. In the event of having to
15
4