Table of Contents
Advertisement
The internal recorder is always storing the
audio from the radio selected for transmit.
To play back the last incoming audio,
hold the RCV (top) button on the radio
selected to transmit for one second, and
release. The playback will start. Playback
stops if the radio becomes active, but the
new incoming message will not be re-
corded. When the radio stops, press play
and you will be in the same message you had playing.
To hear an earlier message, hold the COM RCV button until playback
stops again, and then press again to begin playing the next earlier mes-
sage. Repeat until you hear the message you wanted. Incoming new
messages will stop playback, and you can then restart.
A remote playback switch may also be installed.
Note: when you switch from one transmitter to another, the recordings
are lost.
This chart shows you what the blinking LEDs mean.
What is blinking?
COM 1 or COM 2 XMT
COM 1 or COM 2 RCV
ICS mode
Mute and SPR buttons
August 2012
Recorder Playback
Blinking indicators
How often?
Every 1 second
Every 3 seconds
Every 3 seconds
Every 1 second
KMA 30 Pilot Guide
What it means
Pilot or copilot is transmitting
Monitor mode activated
Pilot has music in ISO
PA Mode active
Page 13
Advertisement
Table of Contents
