Novamatic TK7656 Operating Instructions Manual page 18

Problem
Loading door does not open
with DOOR (TÜR) button.
Loading door does not close.
When a button is pressed,
Err appears in the multi-dis-
play.
Drum light does not work.
PROGRAMME TIME
(LAUFZEIT) display changes
erratically or stays unchanged
for a long time.
Programme inactive, EMPTY
WATER (BEHÄLTER) display
illuminated.
Drying cycle ends shortly after
programme starts. END
(ENDE) display illuminated.
Drying cycle lasts an unusual-
ly long time.
Note:
After around 5 hours the dry-
ing cycle ends automatically
(see „Drying cycle complete").
18
Possible cause
Mains plug disconnected.
Programme selector in OFF (AUS)
position.
Fine strainer not in place and/or
large mesh filter not locked in place.
Washing protection. After the start of
the programme, the option can no
longer be set.
Programme selector in OFF (AUS)
position.
Defective light bulb.
Programme time is corrected auto-
matically depending on type and
volume of laundry and level of
dampness.
Condensate tank is full.
Not enough washing loaded or
washing loaded is too dry for select-
ed programme.
Lint filter clogged.
Heat exchanger clogged with lint.
SPECIAL CARE (SCHON) button
pressed and load volume too big.
Load volume too big.
Laundry insufficiently pre-drained.
Remedy
Plug in at mains socket.
Set programme. Loading door can be
opened at any time by exerting pres-
sure on the door.
Install fine strainer and/or snap large
mesh filter into place.
Turn the programme knob to OFF
(AUS). Set the programme again.
Turn programme selector to LIGHT (BE-
LEUCHTUNG) or to any programme.
Replace light bulb (see next section).
Automatic process; this is not a ma-
chine fault.
Empty condensate tank, then start pro-
gramme with START/PAUSE button.
Select time programme or higher drying
level (e.g. INTENSIVE DRY [STARK-
TROCKEN] instead of STORAGE DRY
[SCHRANKTROCKEN]).
Clean lint filter.
Clean heat exchanger.
SPECIAL CARE (SCHON) is only suita-
ble for use with loads of up to 3kg!
Reduce load volume.
Laundry must be adequately pre-
drained.