Table of Contents
Advertisement
Location
The appliance should be installed well away from
sources of heat such as radiators, boilers, direct
sunlight etc.
For safety reasons, minimum ventilation must be as
shown in Fig.
Appliance positioned under overhanging kitchen wall
units (see A).
Appliance positioned without overhanging kitchen
wall units (see B).
Attention: keep ventilation openings clear of
obstruction.
Two adjustable feet at the cabinet base allow
accurate levelling of the appliance.
Changing the opening direction of
the doors
Before carrying out the operations described below,
pull out the mains plug from the wall socket.
To carry out door reversal operate as follows:
1. Remove feet (2-3).
2. Remove bottom hinge (1);
3. Slide out the lower door from middle hinge (H)
and remove the latter;
4. Slide out the upper door from pin (G), unscrew
the latter and then screw it down into the hinge
provided on the opposite side;
5. Remove the two plugs, to reveal the holes for the
hinge pivots, and remount them on the other
side;
6. Refit the upper door and the middle hinge on the
opposite side;
7. Refit the lower door and bottom hinge (1) on the
opposite side.
8. Refit foot (2-3).
9. Unscrew the handle. Refit it on the opposite side
after having pierced the plugs with a punch.
Cover the holes with the plugs contained in the
documentation pack..
Important
For the alignement of the doors, adjust the middle
hinge horizontally, after having loosened the two
screws.
Attention
After completion of the door reversibility opera-
tion, verify that the door gasket is adherent to the
cabinet. If the ambient temperature is cold (i.e. in
Winter), the gasket may not fit perfectly to the
cabinet. In that case, wait for the natural fitting of
the gasket or accelerate this process by heating
up the part involved with a normal hairdrier.
A
B
NP004
H
PR24
D590
3
D715
D162
G
1
2
17
Hide quick links:
Advertisement
Table of Contents
