Electrolux EWF 106210 A User Manual page 15

Problem
The spin phase does
not operate.
There is water on the
floor.
You cannot open the
appliance door.
The appliance makes
an unusual noise.
The appliance fills with
water and drain imme-
diately.
The washing results
are not satisfactory.
After the check, activate the appliance. The programme continues from the point of inter-
ruption.
If the problem occurs again, contact the service centre.
Service
Refer to the information supplied with this
appliance for guarantee condition and point
of contact. The information to give to the
service is on the rating plate.
Possible cause
The connection of the water
drain hose is not correct.
A washing programme without
the drain phase is set.
The function Rinse Hold is on.
The spin phase is off.
The filter of the drain pump is
blocked.
Balance problems with the
laundry load.
Leakages from the couplings
of the water hoses.
Leakages from the drain
pump.
The water drain hose is dam-
aged.
The washing programme is in
operation.
There is water in the drum.
Incorrect level of the appli-
ance.
You did not remove the pack-
aging and/or the transit bolts.
The load is very small.
The end of the drain hose is
too low.
The detergent you used was
not sufficient or correct.
You did not remove the stub-
born stains before you wash
the laundry.
Incorrect temperature was set.
Too much laundry load.
Possible solution
Make sure that the connection is cor-
rect.
Set the drain programme.
Set the drain programme.
Set the spin programme.
Clean the filter of the drain pump. Refer
to 'Care and cleaning'.
Adjust manually the items in the tub and
start the spin phase again.
Make sure that the couplings are tight.
Make sure that the drain pump filter is
tight.
Make sure that the water inlet hose has
no damages.
Let the washing programme end.
Set the drain or the spin programme.
Adjust the level of the appliance. Refer
to 'Installation'.
Remove the packaging and/or the trans-
it bolts. Refer to 'Installation'.
Add more laundry in the drum.
Make sure that the drain hose is in the
correct position. Refer to 'Installation'.
Increase the detergent quantity or use a
different one.
Use special products to remove the
stubborn stains.
Make sure that you set the correct tem-
perature.
Decrease the laundry load.
We recommend that you write the
information here:
Model
Product number
Serial number
(S.N.)
electrolux 15
..................
914.............
..................