Switching On/Off Setting The Dishwashing Programme - AEG ÖKO FAVORIT 4020 Operating Instructions Manual

Aeg dishwasher
Table of Contents

Advertisement

Switching on/off
Setting the dishwashing programme
Check that the crockery and cutlery in your dishwasher are arranged so that
the spray arm is not obstructed.
Close the door.
Fully turn on the water tap, if it is off.
Important! If a washing programme has been started despite the water tap being
turned off, switch off your machine, turn on the water tap, and reset the washing
programme.
Setting the dishwashing programme
Turn the programme switch clockwise to position A or B as shown in the pro-
gramme chart.
Turn the programme selector to the programme you require (see "Programme
chart"). The programme starts.
During the programme cycle, the programme cycle indicator cycles forward,
indicating the status of the machine washing programme in each step. During
heating in the washing and rinse aid cycles, the programme switch remains
stationary until the necessary temperature is attained.
Programme correction
You can correct any washing programme you have inadvertently set wrongly
by switching off your machine with the programme selector (
Important! For reasons of radio interference suppression, you should operate
the programme switch only when your machine is switched off. Automatic
detergent addition could also be tripped.
Caution! Hot steam may emerge when the door is opened. Take care
you do not scald yourself! Open the door carefully.
Reset the washing programme you require.
Interrupting the programme
Caution! Hot steam may emerge when the door is opened. Take care
you do not scald yourself! Open the door carefully.
A running washing programme is interrupted if you open the door.
Reclose the door. The washing programme restarts from the position where it
was interrupted.
You should open the door during the programme cycle only when absolutely
necessary (blocked spray arm). When you reclose the appliance, the penetrat-
ing air is strongly heated and expands. This may lead to programme cycle
irregularities requiring service centre attention.
26
position).

Advertisement

Table of Contents
loading

This manual is also suitable for:

Oko_favorit 4020

Table of Contents